541-942-5920
9605DEK $699.00
Complete Custom Cooling System for Street or Strip
Available with Upper and Lower hose in ANY position
Kit contains these components:
#9605DEK 19H x 28" or 31"W Pro Radiator
#Dual 10"-11" or 12" electric cooling fans and Shroud (as applicable)
TIG Welded Angle mounts
Dual Fan wiring harness with relay
Thermostat control Screw in sensor
Polished cap
Overflow fitting
Your color choice Trim Cap
All Kits are shipped with Kool-IT
Assembly
Service available see below.
These radiators also come with a drain cock as standard equipment (Not Shown)
Add $69.00 for Tranny Cooler
Completely Assembled Cooling System:
Fan mounted to radiator, overflow nipple, install trim strip, TIG Welded Brackets,
ready to bolt In place and plug in the electrical Add $89.00
Other Items Also available for this style radiator but NOT Included as part of the kit:
17" x 2"
Or 15" x 2"
12016 Polished stainless steel overflow bottle for full recovery system 17" or 15" x 2"
Mounts to core support or radiator flanges depending on radiator installation and type.
$49.00
Pi-Thon Radiator Hose Clamps
Go From This 
To This 
Pi-Thon Hex (as shown) or Spanner Wrench style Available as a kit with True SS Braided Sleeve and clamps to fit our Radiator inlet and outlets and your thermostat housing.
2- Pi-Thon Spanner Clamps, 2-Spanner wrenches, 30" SS Braided Sleeve $79.95
Or fit you rubber hoses, send them to us and we'll sleeve them and install the correct clamps.
Available in Blue, Red, Black or Clear (As Shown)
Assembly notes: Components are assembled using aluminum pop rivets, this kit is designed to bolt to core support, to complete the installation you will need to weld, pop rivet or bolt on flanges and drill to mount to core support. Temp sensor is 3/8 NPT and should be installed in a water passage in the block, heads or water port of the intake manifold (Recommended).
If your using AN line for the overflow nipple we will install a 1/8th NPT to -06 adaptor, please specify.
Back to Cooling System kits Index
Call 541-942-5920 9am - 7pm EST
Tech Tip:
When mounting the overflow tank for a recovery system tank we recommend that you try and get the top of the tank at or below the top of the radiator.