541-942-5920
9600EK $479.00
Complete Cooling System for Street or Strip
Available with lower hose left or right side
Kit contains:
#9600BK 19 Tall x 22 Wide Pro Radiator
#40000 14" electric cooling fan and Shroud
Fan harness with relay
Thermostat control
Polished cap
Overflow fitting
Clear Trim Cap
All Kits are shipped with Kool-IT
Assembly Service available see below.
This
kit is available with the Drivers side lower or Upper the Passenger side is
always on the opposite corner. The water neck or cap is always above the
lower hose.
Add $69.00 for built in Tranny Cooler
Add $109.00 for Tranny cooler line kit which contains 12 feet -06 SS Hose and all fittings to install.
Completely Assembled Cooling System:
Fan mounted to radiator, overflow nipple, trim strip installed- ready to bolt In place and plug in the electrical Add $79.00
Other Items Also available for this style radiator but NOT Included as part of the kit:
17" x 2"
Or 15" x 2"
12016 Polished stainless steel overflow bottle for full recovery system 17" or 15" x 2"
Mounts to core support or radiator flanges depending on radiator installation and type.
$49.00
Pi-Thon Radiator Hose Clamps
Go From This 
To This 
Pi-Thon Hex (as shown) or Spanner Wrench style Available as a kit with True SS Braided Sleeve and clamps to fit our Radiator inlet and outlets and your thermostat housing.
2- Pi-Thon Spanner Clamps, 2-Spanner wrenches, 30" SS Braided Sleeve $79.95
Or fit you rubber hoses, send them to us and we'll sleeve them and install the correct clamps.
Available in Blue, Red, Black or Clear (As Shown)
Completely Assembled Cooling System:
Fan mounted to radiator, overflow nipple, trim strip ready to bolt In place and plug in the electrical Add $79.00
Assembly notes: Components are assembled using aluminum pop rivets, this kit is designed to bolt to core support, to complete the installation you will need to drill holes in the core support and bolt securely. Temp sensor is 3/8 NPT and should be installed in a water passage in the block, heads or water port of the intake manifold (Recommended).
If your using AN line for the overflow nipple we will install a 1/8th NPT to -06 adaptor, please specify.
Back to Cooling System kits Index
Call 541-942-5920 9am - 7pm EST
Tech Tip:
When mounting the overflow bottle on a recovery system tank we recommend that you try and get the top of the tank at or below the top of the radiator.