541-942-5920
9600RacePakEK $619.00
Complete Cooling System for Strip
Available with Upper and Lower hose in either position
Kit contains:
Race Pro 19 x 22" or 24"
16" Extreme Duty 3000 CFM Race Fan
Wiring Harness
Mount kit
Edge seal gasket
TIG Welded Angle mounting brackets installed
Adjustable Thermostat control
20# Race cap
Overflow fitting (specify AN or Push-fit)
Your color choice Trim Cap
Drain Cock installed (Not shown)
All Kits are shipped with Kool-IT
Assembly
Service available see below.
These radiators come with a drain cock as standard equipment (Not Shown)
Radiators are 2.25" thick all other dimensions are OD
Mounting Brackets will add 1.5" each or 3" Overall width
Extreme Race cooling fans are 3.75 thick
Note: This is a Race Only or very light Street Duty System
Add $69.00 for Tranny Cooler
Completely Assembled Cooling System:
Fan mounted to radiator, sealing gasket, overflow nipple, install trim strip, ready to bolt In place and plug in the included electrical Harness Add $59.00
Other Items Also available for this style radiator but NOT Included as part of the kit:
17" x 2"
Or 15" x 2"
12016 Polished stainless steel overflow bottle for full recovery system 17" or 15" x 2"
Mounts to core support or radiator flanges depending on radiator installation and type.
$49.00
Pi-Thon Radiator Hose Clamps
Go From This 
To This 
Pi-Thon Hex (as shown) or Spanner Wrench style Available as a kit with True SS Braided Sleeve and clamps to fit our Radiator inlet and outlets and your thermostat housing.
2- Pi-Thon Spanner Clamps, 2-Spanner wrenches, 30" SS Braided Sleeve $79.95
Or fit you rubber hoses, send them to us and we'll sleeve them and install the correct clamps.
Available in Blue, Red, Black or Clear (As Shown)
Completely Assembled Cooling System:
Fan mounted to radiator, sealing gasket, overflow nipple, install trim strip, ready to bolt In place and plug in the included electrical Harness Add $59.00
Assembly notes: Components are assembled using aluminum pop rivets, this kit is designed to bolt to core support, to complete the installation you will need to drill holes to mount to core support. Temp sensor is top hose clamp in type.
If your using AN line for the overflow nipple we will install a 1/8th NPT to -06 adaptor, please specify.
Back to Cooling System kits Index
Call 541-942-5920 9am - 7pm EST
Tech Tip:
When mounting the overflow tank for a recovery system tank we recommend that you try and get the top of the tank at or below the top of the radiator.